Why do I see a ghost image or residual artifacts from the previous image?
Quick answer
Ghost images occur when the lens cover isn’t closed during manual calibration. Close the cover or switch to automatic calibration mode.
This issue occurs if you’re using manual calibration mode without closing the lens cover.
To fix this:
- Ensure the lens cover is closed during manual calibration.
- Alternatively, switch to automatic calibration mode if you prefer not to close the cover.
Thermal Imaging Attachments Common Questions
I hear a clicking sound during calibration. Can I disable it?
What is the purpose of the User Mode on Pulsar thermal imaging devices?
Do I need permission to travel with my thermal attachment to another country?
Can I safely use the Krypton 2 on an air or pellet gun?
Can Pulsar attachments be used with a SCAR 17s rifle known for its strong recoil?
Are user zeroing profiles retained after updating the attachment’s firmware?
Does the attachment support wireless remote control?
Can the attachment be powered with a 12V car adapter?
What should I do about defective pixels on my thermal imaging device screen?
Why is it necessary to calibrate the image on a thermal imager?
Do I need to zero the Krypton attachment?
Why does my image freeze from time to time? Is it a defect?
What should I do if my attachment doesn’t hold zero?
Can Pulsar attachments be used with a SCAR 17s rifle known for its strong recoil?
Can I use the 3x20B monocular without removing the PSP adapter?
Can the Krypton 2 be used as a handheld monocular?
Can the Krypton 2 be mounted on a Picatinny rail?
What should I do if I’m experiencing issues with the point of impact?
Are there multiple zeroing profiles available for using the attachment on different rifles?
Still have a question?
Feel free to get in touch